Advantages of LizardSkin Versus Competitive Insulating Products that are cut & glued Material

Lizard SkinT applied to the interior of a car requires only 0.040"to-0.060" thickness

• Competitive insulations are 1/2 to 1 inch in thickness.

Lizard SkinT is applied with one continuous coating, leaving no seams or separations to allow heat, sound or moisture to enter.

• Competitive insulations have seams that separate over time and allow heat, sound or moisture to enter, thus reducing the benefits of the original insulation.

Lizard SkinT can insulate the whole body of the car, including frames and ribs, not just sections. This is not only critical for hot and cold, but is even more critical for acoustical purposes. This enables LizardSkin to absorb noise energy and block noise attenuation picked up from the tire and road noise. This also helps to improve the stereo sound system even more.

• Competitive insulations cannot effectively insulate the frame, ribs and non- flat surfaces of the car.

Lizard SkinT adheres directly to the surface of the car. It does not require adhesives that will come loose from vibration and heat. LizardSkin is applied in one easy application.

• Competitive insulation's are held in place with expensive adhesives that can break down in time after solar heat gain and vibration, thus releasing the insulation from the ceiling, or doors of the car causing a loss in the ability to insulate and lower decibel levels.
• Competitive insulation's are labor intensive and difficult to install.

Lizard SkinT is water resistant, thus it does not accumulate moisture. LizardSkin adheres directly to the surface of the car, thus becoming a corrosion inhibitor without the accumulation of moisture, which makes it excellent for insulating door panels.

• Competitive products generally have materials in them that absorb moisture that in turn can cause rust and corrosion inside the car. Also, once the insulation gets wet, it is no longer effective insulation or sound reduction.
• Competitive products should not be applied to the inside of doors or side panels because they can collect moisture, rot, mold and mildew and cause rust to the door panels.

Lizard SkinT is a biodegradable and non-toxic insulation and sound- deadening product that cleans up with soap and water and is Class A fire rated.

• Competitive products are held in place with glues comprised of toxic components.
• Competitive under-coatings are full of petrochemicals and toxic components that when they get hot can sweat out of the coating leaving them brittle.

Lizard SkinT can even be used to coat the entire bottom of the floor pan and the underside of fenders to guard against starburst on the fenders. And the fiberglass cracking.

• There is no competitive insulation or sound deadening materials that can be applied to the bottom of the car.

Lizard SkinT can be applied to the outside of fuel tanks to reduce temperature gain to fuel.

• No blanket insulators can be attached to the outside of the fuel tank .

Lizard SkinT can even be painted body color for the bottom of car or the engine compartment firewall.

• Blanket insulation cannot be painted.

Lizard SkinT can be applied by brush, roller or spray method. (special gun is needed)

back to top